#Lcd1602 arduino uno pinout how to
#Lcd1602 arduino uno pinout serial

For Mega2560: the I2C connections are on SDA=20 and SCL=21.

To do this, connect the pins as follows: OsoyooВ UNO ConnectionД«efore you write the code you have to build the circuit. The blue potentiometer on the I2C LCD1602 (see the figure below) is used to adjust the backlight for better display.And there is a jumper on the board, if you take away this jumper, the backlight will aways be off.ДЇor the usagage of other functions, pleae refer to the вЂњLiquidCrystal_I2C.hвЂќ in the sourcecode of I2C LCD library. The usage voltages are standard as 5V and 3.3V. Both must be connected via pulled-up resistors.

#Lcd1602 arduino uno pinout serial

I2C is a type of serial bus developed by Philips, which uses two bidirectional lines, called SDA (Serial Data Line) and SCL (Serial Clock Line). The LCD1602 display has an integrated microchip that manages this type of communication, and then all of the input and output information are limited to only two PINs (excluding power supply). This problem has been solved thanks to the communication on the I2C bus. When they are connected to a microcontroller (such as Arduino for example), these displays require virtually many connection PINs occupying practically almost all available IO and leaving the multiprocessor few outputs for any other devices and sensors. However, these displays have a small problem. These values can be either a simple text or numerical values read by the sensors, such as temperature or pressure, or even the number of cycles that the Arduino is performing. The integration of an LCD display greatly facilitates the interactivity of the project you are developing, allowing the user to directly read some output parameters. Osoyoo UNO Board (Fully compatible with Arduino UNO rev.3) x 1.

#Lcd1602 arduino uno pinout how to

Finally you will see how to program it with a simple example showing how to display text on the display. In this lesson we will showВ how to mount a LCD display on your Arduino using the I2C communication. During the building of your projects for Arduino, youвЂ™ll often need to read the output data directly from a LCD display.